MOOSE RACING Water Pump Rebuild Kit 821328MSE Taillight and License Plate Holder with Turn Signal Works seamlessly with Cobra® detachable

Works seamlessly with Cobra® detachable back rests Same proprietary release mechanism as the back rests Installed or removed in a matter of seconds Can be used with or without back rests but requires stock or Cobra® hardware kit

New Silencer Design Featuring: Carbon Sleeve with Carbon Fiber End Cap and stainless steel exhaust tubing

2010-2016 Honda VT1300CR Stateline - - 2010-2016 Honda VT1300CS Sabre - - 2010-2016 Honda VT1300CX Fury - -

while allowing more airflow than two separate layer filters (flow bench proven) Twin Air filters are slightly smaller than stock to make them easier to change and to increase dead air space around the filter for better performance

Delivers a deep sonic thump that keeps that powerful V-Twin rhythm going for miles and miles

MOOSE RACING Water Pump Rebuild Kit 821328MSE Taillight and License Plate Holder with Turn Signal Works seamlessly with Cobra® detachableInclude every gasket, O ring, bearing and seal required to rebuild a water pump Typical kit includes the following: bearings where applicable; rubber seals; mechanical water pump seal where applicable; side cover gasket; water pump gasket; snap rings located on water pump shaft and copper drain washers